I ordered this bumper from a store Czechoslovak and unfortunately arrived damaged from here near the break ...
Overview of the bumper to the left you can already see that I sanded and placed the tape so that it does not protrude from resin by adding ...
Then I sanded the inside ...
I sanded really bad ... I first used the drill with a bit of thread made of iron, then I know that annoyed us put time and I used my friend Flex, losing its original shape ... now I'll have to reconstruct the original form :-(
This is the result after internal resin, as I go about this? before I took a little fibbre say 2cm for 4, then I soaked well and good for in fact the best way to fill the crack. After lying good for this little piece of fibers, I used a much bigger say 15cm to 20, and I stretched out being careful not to create bubbles. I have a little abounded with resin ...
And this is the tape a bit faded from the resin
Here is the result after the resin has dried up and removing the tape
This is look after you apply a piece of fiberglass (naturally has already been adequately sandpaper), I used the fiberglass also filing out why I removed too much material ...
Immediately after I've applied a layer of fiberglass plaster at best.
Beautiful filed
I made another layer of fiberglass stucco
Since I was there I also adjusted the right side that was not finished very well there was a kind of hollow ...
0 comments:
Post a Comment